HIKVISION DS-7604 Series Quick Start Manual

Quick Start Guide

DS-7604 Series DVR

Menu Structure

The menu structure of the DS-7604 Series DVR is as
followed:

Startup and Shutdown

Proper startup and shutdown procedures are crucial to
expanding the life of your DVR.
To start your DVR:
1. Ensure the power supply is plugged into an electrical
outlet. It is HIGHLY recommended that an
Uninterruptible Power Supply (UPS) is used in
conjunction with the unit.
2. Press the POWER switch on the rear panel. After the
power has been started up, the POWER indicator will
light green.
To shutdown the DVR:
1. Enter the Shutdown menu by clicking on Menu >
Shut down.
2. Select the Shutdown button.
3. Click the Yes button.
(V1.0.3N)
Using the Setup
Wizard
By default, the Setup Wizard will start once the DVR has
loaded. The Setup Wizard will walk you through some of the
more important settings of your DVR. If you do not wish to
use the Setup Wizard at this time, click the Cancel button.
You may also choose to use the Setup Wizard at a later time
by leaving the "Start Wizard when DVR starts?" checkbox
checked.
To start using the Setup
Wizard:
1. Click the Next button
on the Wizard
window.
This will take you to
the User Permission
window.
2. Navigate to the Admin
Password input field.
3. Enter the admin password into the Admin Password input
field. By default, the
password is 12345.
4. To change the admin
password, check the
New Admin
Password checkbox.
Enter the new
password and confirm the password in the given fields.
5. Click the Next button. This will take you to the HDD
Management window.
12. To start HDD
management, click the
Enter button.
13. If a new HDD was
recently installed,
Quick Start Guide - DS-7604 Series DVR 1