Configuring Alarm Inputs - HIKVISION DS-7604 Series User Manual

User Manual of DS-7604 Series DVR
2. Select the camera to configure in the camera drop down menu on the upper left of the menu. If
all cameras are to be configured with the same settings, select All Cameras from the list.
3. Check the Enable Motion Detection checkbox to enable motion detection for the selected
camera. Uncheck the checkbox to disable motion detection.
4. Set the motion detection sensitivity by adjusting the green Sensitivity bar. The more lime green
rectangles selected in the bar, the higher the sensitivity will be to motion.
5. Set the motion detection region in the preview screen on the right side of the menu by left-
clicking with the mouse on an open area. A red grid will be shown, designating that the selected
area is part of the motion detection region. Dragging or left-clicking on areas that overlap the
current selected motion detection area will include them into the region. You may also click the
Full Screen button to include the whole area into the motion detection region. Left-clicking on
any part of the grid will remove that section from the motion detection region.
6. If you‟re not satisfied with the selected region, you may click the Clear button to reset the
motion detection area.
7. Select the Actions to take if motion is detected in the designated regions. More than one action
can be selected. The actions available include:
Sound Audio Warning: DVR will sound an audio warning if motion is detected in the designated
regions of the camera.

op-up Image on Monitor: DVR will show an image of what caused the motion on the
P
monitor.

Notify Surveillance Center: DVR will notify surveillance center when motion is detected.

Send Email: DVR will send an email out to the designated recipients when motion is
detected.

Trigger Alarm Output: DVR will trigger alarm output when motion is detected. Selecting
this option will enable the Alarm Output list, where the output to trigger can be selected.
8. Select the Save button to save the motion detection settings and select Exit to return to the
previous menu. Selecting the Exit button without clicking Save will quit out of the menu without
saving settings.

Configuring Alarm Inputs

Recordings can also be triggered from an external sensor alarm device. To setup recording triggers from
alarm inputs:
1. Enter the Trigger Settings menu, shown in Figure 42 by going to Main Menu > Recording
Configuration > Trigger Settings.
53