Customizing Ptz Presets, Patterns And Patrols - HIKVISION DS-7304HFI-SE User Manual

User Manual of DS-7304HFI-SE DVR
4. Using the Directional buttons and other PTZ control buttons (Zoom In/Out, Focus In/Out, Iris In/Out), test the
functionality of the PTZ camera. If PTZ camera and protocol supports it, you may also click the Auto-Scan button to
test its function. PTZ controls buttons are shown in Figure 39.
5. If PTZ camera is not working properly, make sure PTZ is connected and configured with the correct settings under the
Serial Settings tab.
6. Click Done to exit and return to the previous menu.

7.3.2 Customizing PTZ Presets, Patterns and Patrols

Your DVR allows you to customize presets, patterns and patrols for a connected PTZ ,camera. A PTZ camera must first be
configured before PTZ presets, patterns and patrols can be customized (See Configuring Basic PTZ Settings on page 45).
To customize PTZ presets:
1. Enter the PTZ Configuration menu, shown in Figure 38 by going to Main Menu > System Configuration > PTZ
Configuration.
2. Select the On Camera Settings tab.
3. Select Save Presets and move the camera to the desired position using the PTZ control buttons.
4. Double-click on a preset number in the upper left corner of the screen. The current position of the PTZ camera will be
set for the selected preset number.
5. To test the newly configured preset, first move the PTZ camera to a different position. Select Recall Presets and click
on the preset number. The camera should move to the location that was set for the selected preset number.
6. Click the Done button to exit out of the PTZ Configuration menu.
Note:
Only the first 23 presets are shown in the table. To save or recall more presets, click on the "..." button. Clicking the "..."
button will bring up a selection list for presets up to 200.
To customize PTZ patterns:
1. Enter the PTZ Configuration menu, shown in Figure 38 by going to Main Menu > System Configuration > PTZ
Configuration.
2. Select the On Camera Settings tab.
3. Select a Pattern Number to set from the drop down list.
4. Click the Record button to begin recording the movement of the PTZ.
5. Move the PTZ to the desired locations using the PTZ control buttons.
6. Click the Save button to save pattern.
7. To test out your new pattern, click the Play button. The PTZ should move as it did during the recording process. You
may click the Stop button at any time to end the pattern. Clicking the Play button again will start playing the PTZ
pattern again at the initial position.
8. Click the Done button to exit out of the PTZ Configuration menu.
To customize PTZ patrols:
1. Enter the PTZ Configuration menu, shown in Figure 38 by going to Main Menu > System Configuration > PTZ
Configuration.
2. Select the On Camera Settings tab.
3. Select a Patrol Number to set from the drop down list.
4. Select a Preset Number that is next to the Patrol Number from the drop down list that you would like to add to the
patrol.
5. Click the Add button. The Preset Number will be added to the patrol list.
6. Repeat steps 4-5 until you have included all the presets you would like to have on the patrol.
7. Click the Up and Down button at the bottom of the list to change the order of the presets in the patrol.
8. To test out your new preset, click the Play button. The PTZ should move through the list of added presets.
9. Click the Done button to exit out of the PTZ Configuration menu.
Figure 39. PTZ Controls Button
46