HIKVISION DS-7604 Series User Manual page 34

User Manual of DS-7604 Series DVR
2. Select the camera to configure from the camera drop down menu. If all the cameras are to be
configured with the same settings, select All Cameras from the list.
3. Check the Enable checkbox to enable the recording schedule. If the checkbox is unchecked, the
recording schedule will be disabled.
4. Select a day between Monday to Sunday to configure schedule for.
5. Setup time periods for schedule. If the 24HR checkbox is checked, recording will occur over the
entire day. To setup multiple time periods, uncheck 24HR and enter the Start and Stop Time for
the selected day. The start and stop time are listed using a 24 hr cycle (i.e. 18:00 is equivalent to
6:00pm).
6. Select recording type under Type for selected day of the week. Recording type includes
Continuous for continuous recording or On Event for recording when an event is triggered (i.e.
from detected motion) for the selected time period.
7. If there are scheduling errors detected, such as overlapping time periods, error messages such as
those shown in Figure 24 will appear.
8. Select the Add button to add time frame to schedule. The newly added time frame will appear in
the schedule on the left, with the schedule parameters shown on the right. Continuous recordings
are shown in blue on the schedule while event recordings are shown in yellow. An example of
this can be seen in Figure 25.
9. Repeat steps 4-10 to setup additional time periods for the selected day.
Figure 24. Advanced Schedule Configuration Error Messages
Figure 25. Advanced Schedule Configuration Example
34