Power supply
6.1
Replacing the power supply unit
Field Replaceable Units (FRU)
Average task duration: 10 minutes
6.1.1
Required tools
Preliminary and concluding steps: tool-less
●
Replacing the power supply unit:
●
– Phillips PH2 / (+) No. 2 screw driver
6.1.2
Preliminary steps
Before replacing the power supply unit (PSU), perform the following steps:
I
You are advised to perform this routine with the server in a horizontal
position.
Ê Shut down the server as described in section
page
40.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Open the side cover as described in section
page
43.
74
"Disconnecting the power cord" on page
Upgrade and Maintenance Manual
"Shutting down the server" on
"Removing the side cover" on
TX100 S3 Core Edition
41.