Updating The Bios - Fujitsu PRIMERGY TX100 S3 Core Edition Upgrade And Maintenance Manual

System board and components
Ê Switch on the Headless server.
The "Headless" update tool will now start from the attached USB stick. The
activity LED on the USB stick (if present) will flash in intervals at a high
frequency, indicating read access.
– As soon as the "Headless" update has been applied successfully, the
power-on LED of the server will start flashing continuously at a low
frequency of 1/2 Hz (once in two seconds).
– In case of problems during the conversion process, the power-on LED of
the server will start flashing in 5-second intervals at a frequency of 1 Hz,
followed by five second pauses.
Ê Switch off the server after the conversion process, remove the USB stick and
re-connect the SATA cables to the hard disk drives as described above (see
the cabling plans in section

14.2.3 Updating the BIOS

V
After replacing the system board, it is essential to upgrade the BIOS to
version 1.4.0 or higher before proceeding.
The latest BIOS version is available from the Fujitsu Technology Solutions
support web pages at:
apply to the Japanese market).
I
The required BIOS image is the same as for the standard (non-
Headless) TX100 S3 server. Please look for "TX100 S3" update files.
Ê Apply the BIOS update as described in section
BIOS via USB stick" on page
I
This procedure does not apply to the Japanese market. Please follow
the update procedure intended for the Japanese market.
214
"Cabling overview" on page
http://ts.fujitsu.com/support/
67.
Upgrade and Maintenance Manual
218).
(download location does not
"Updating the system board
TX100 S3 Core Edition