Hot-plug components
8.1
Hot-plug components
8.1.1
Hot-plug power supply units
With two hot-plug power supply units installed, if a defect occurs in one power
supply unit, the other power supply unit ensures unimpaired further operation.
The defective power supply unit can be replaced during operation (hot
plugging).
V
CAUTION!
It is essential to observe the safety instructions in chapter
information" on page
8.1.1.1
Replacing the hot-plug power supply unit
Figure 29: Unlocking and removing the power supply unit
V
CAUTION!
When replacing a non-defective hot-plug power supply unit in a non-
redundant configuration (only one power supply unit), the server must
be switched off first.
92
23.
Operating Manual
CSS components
2
1
"Important
TX150 S6