Processor
11.3.2 Preliminary steps
Before replacing the processor heat sink, perform the following steps:
Ê Shut down the server and disconnect the AC power cord from the system as
described in section
Ê Bring the server to its horizontal position.
11.3.3 Removing the processor heat sink
Ê Remove the processor heat sink as described in section
processor heat sink" on page
11.3.4 Applying thermal paste
Ê Apply the thermal paste as described in section
page
140.
11.3.5 Installing the processor heat sink
Ê Install the processor heat sink as described in section
processor heat sink" on page
11.3.6 Concluding steps
Perform the following procedures to complete the task:
Ê Close the side cover as described in section
page
56.
Ê Reconnect the AC power cord(s) to the power supply unit(s) as described in
section
"Switching on the server" on page
Ê Reconnect the AC power cord to the power supply unit and secure it with a
cable tie as described in section
page
57.
146
"Shutting down the server" on page
131.
142.
"Connecting the server to the mains" on
Upgrade and Maintenance Manual
40.
"Removing the
"Applying thermal paste" on
"Installing the
"Installing the side cover" on
58.
TX100 S3 Core Edition