Replacing The Power Supply Unit - Fujitsu PRIMERGY CX120 S1 Service Supplement Manual

Replacing the power supply unit

4.9 Replacing the power supply unit
Ê Open the server as described in
Ê Remove all components except the power supply unit from the chassis as
shown in the related sections:
– Heat sinks:
– Processors:
– Memory modules:
– Expansion cards:
– PCI riser card:
– RMM3 module:
(RMM3)" on page 45
– System board:
Ê Remove the server cover from the replacement chassis as described in
section "Opening the server" on page
72
section "Removing a heat sink" on page 51
section "Removing a processor" on page 53
section "Removing a memory module" on page 63
section "Replacing expansion cards" on page 40
section "Replacing the PCI riser card" on page 44
section "Replacing the Remote Management Module
section "Replacing the system board" on page 65
Service Supplement
A pre-assembled replacement
chassis / PSU kit is available
under the following part
number:
S26361-K1348-V900
I
section "Opening the server" on page
29.
The CX120 S1 PSU
(460 W, open frame) is
not available as a
separate spare part.
PRIMERGY CX120 S1
29.