Hot-plug components
8.1.1.3
Replacing the hot-plug power supply unit
V
CAUTION!
Before replacing a non-defective power supply unit in a non-redundant
configuration (only one power supply unit present), the server must be
switched off.
Ê Remove the cable of the defective power supply unit.
Figure 18: Unlocking and removing the power supply unit
Ê Push the green catch to the left (1).
Ê Pull the power supply unit out of its mounting location (2) by the handle.
Ê Install the new power supply unit in the empty mounting location (see section
"Installing the hot-plug power supply unit" on page
Ê Connect the newly installed power supply unit (see section
server to the mains" on page
82
52).
Operating Manual
CSS components
81).
"Connecting the
RX200 S5