12.3
Removing accessible drives
Upgrade and Repair Units (URU)
Average task duration: 10 minutes
12.3.1 Required tools
Preliminary and concluding steps: tool-less
●
Removing accessible drives: tool-less
●
12.3.2 Preliminary steps
Before removing an accessible drive, perform the following steps:
Ê Remove all backup and optical disk media from backup and optical disk
drives as described in section
page
65.
Ê Verify if your backup software solution requires preparative configuration
before starting the procedure as described in section
configuring the backup software solution" on page
Ê Shut down the server as described in section
page
40.
Ê Remove the power cord from the cable tie and disconnect it from the system
as described in section
Ê Bring the server to its horizontal position.
Ê Open the side cover as described in section
page
43.
TX100 S3 Core Edition
"Removing backup and optical disk media" on
"Disconnecting the power cord" on page
Upgrade and Maintenance Manual
Accessible drives
"Verifying and
66.
"Shutting down the server" on
"Removing the side cover" on
41.
163