Front panel and external connectors
13.2
Replacing the front USB module
Field Replaceable Units (FRU)
Average task duration: 15 minutes
13.2.1 Required tools
Preliminary and concluding steps:
●
– Phillips PH2 / (+) No. 2 screw driver
Replacing the front panel module:
●
– Phillips PH2 / (+) No. 2 screw driver
13.2.2 Preliminary steps
Before replacing the front USB module, perform the following steps:
Ê Shut down the server as described in section
page
40.
Ê Remove the AC power cord from the cable tie and disconnect it from the
system as described in section
Ê Bring the server to its horizontal position.
Ê Open the side cover as described in section
page
43.
Ê Remove all accessible drives as described in section
drives" on page
Ê Remove the front cover as described in section
on page
49.
Ê Remove the HDD cage as described in section
on page
60.
184
"Disconnecting the power cord" on page
163.
Upgrade and Maintenance Manual
"Shutting down the server" on
"Removing the side cover" on
"Removing accessible
"Removing the front cover"
"Removing the HDD cage"
TX100 S3 Core Edition
41.