Table of Contents
Advertisement
4. Set-up
4.3 Communication, Cancel of Digital Input Set-up
6 CC-Link station
number
DISPLAY
SET
7 CC-Link baud rates
DISPLAY
SET
8 Communication
module reset
DISPLAY
SET
9 Digital input reset
SET
Set-up menu
6 Set the CC-Link station number.
In the case of ModBus, this display does not apper.
+
–
,
Settable addresses: 1 to 64
7 Set the CC-Link baud rates.
In the case of ModBus, this display does not apper.
+
–
,
Settable baud rates:
8 Set the communication module reset.
In the case of ModBus, this display does not apper.
+
–
,
Set it ON.
oFF
Note: When it is not set to ON, changed station number and baud rate do not
become valid.
9 Set the digital input(DI) reset method.
Without digital input, this display does not apper.
+
–
,
Auto: Automatic method
Note: When selected the manual method(HoLd), input state is kept until the
cancel operation by the hand. For the method of the cancel operation, refer
to page 44.
According to the set-up diagram (page 13), save the changed
contents or continue to the other set-up menu.
+
–
,
0: 156k
1: 625k
2: 2.5M
3: 5M
4: 10M
on
HoLd: Manual method
Set-up Menu 2
Advertisement
Table of Contents
