Table of Contents
Advertisement
4. Set-up
4.5 Display of Each Measurement, etc. Set-up
In the operation mode, press the
operation becomes available.
Set-up menu
DISPLAY
SET
1 Expanded counting
DISPLAY
SET
2 Harmonics
DISPLAY
SET
3 Digital input/output
DISPLAY
SET
4 Back light
ON/OFF setting
DISPLAY
SET
and the
SET
RESET
Set the set-up menu number to "4". (Set as shown in the right
display.)
+
–
,
1 Set the combination of display for active energy and reactive energy.
Combination of imported/exported and lag/lead can be selected.
Combination 1 in the diagram is the standard use.
Combination
!
+
–
,
@
#
$
Display of combination ! Display of combination @ Display of combination # Display of combination $
2 Set the harmonic measurement.
+
–
on : Harmonic measurement value is displayed.
,
off : Harmonic measurement value is not displayed.
3 Set the display of the digital input/output state.
When the ME-0052-NS96 or ME-0040C-NR96 type optional
plug-in module is not installed, this menu cannot be set.
+
–
,
on : The state of the digital input/output is displayed.
off : The state of the digital input/output is not displayed.
4 Set the back light auto off (Auto)/continuous on (HoLd).
(Setting this is normally unnecessary.)
HoLd
(Continuous ON)
+
–
,
If you set to 'Auto off', the back light turn off when there is no
key operation for 5 minutes. When an operation key is pressed,
it is lit for 5 minutes. At this moment, the display is not changed.
When the operation key is pressed once again, the display is
changed.
simultaneously for 2 seconds or more, and the following
Active energy
(Wh)
Imported
(Exported)
Imported
Imported Exported
lag
(lead)
Auto
(Auto OFF)
Set-up Menu 4
Reactive energy
(varh)
(Exported)
Imported
lead
(lag)
lag
lead
lag
Exported
lead
Advertisement
Table of Contents
