Mitsubishi Electric ME96NSR User Manual page 11

3. Function Modes
■Outline of Function Mode
Operation mode
Measuring and displaying in this mode.
Instantaneous value display
The instantaneous values of the set-up display pattern are displayed. Usually, this display is used.
Maximum value and minimum value display
The maximum values and minimum values are displayed. (see page 39)
Instantaneous value cyclic display change
Instantaneous value displays are automatically changed every 5 seconds. (see page 40)
Instantaneous value cyclic phase change
Instantaneous value phases are automatically changed every 5 seconds. (see page 40)
Maximum value and minimum value cyclic display change
Maximum value and minimum value displays are automatically changed every 5 seconds.
(see page 40)
Maximum value and minimum value cyclic phase change
Maximum value and minimum value phases are automatically changed every 5 seconds.
(see page 40)
Set-up mode
In this mode, all the setting items including primary voltage, primary current, and so forth can be set.
Set necessary items before operation. (see pages 12 to 31)
Set value confirmation mode
This mode is for checking the contents of the set-up items.
In this mode, the contents of the all set-up items are protected from changing accidentally.
(see page 44)
Test mode
In this mode, the output function can be tested, when the option module is installed.
A mock output can be put out even if only it supplies power to the instrument, and there is no input.
This mode is independent of other modes. (see page 33 to 36)