Table of Contents
Advertisement
5. Output Adjustment and How to Test
5.3 Analog Output Test
When the ME-4201-NS96 type optional plug-in module is installed, simulated signal output to test the analog
output circuit can be put out.
Operate it according to the following.
The following operation becomes possible when you turn on the power supply while pressing the
state of power failure.
It is impossible to test without the option module.
Test menu
SET
q Analog output
CH1 test
SET
w Analog output
CH2 test
SET
e Analog output
CH3 test
SET
r Analog output
CH4 test
SET
Test menu
Set the test menu number to "2". (Set as shown in the right
display.)
+
–
,
q Test the analog output CH1.
When the
+
–
,
output CH1 are changed as following.
0%output
w Test the analog output CH2.
When the
+
–
,
output CH2 are changed as following.
0%output
e Test the analog output CH3.
When the
+
–
,
output CH3 are changed as following.
0%output
r Test the analog output CH4.
When the
+
–
,
output CH4 are changed as following.
0%output
In case of test the other output, according to the 5.2 to 5.5,
continue to the test.
+
–
,
When the test is finished, turn off the power supply.
+
–
,
is pressed, the display and the analog
50%output
100%output
+
–
,
is pressed, the display and the analog
50%output
100%output
+
–
,
is pressed, the display and the analog
50%output
100%output
+
–
,
is pressed, the display and the analog
50%output
100%output
at the
DISPLAY
Advertisement
Table of Contents
