Set-Up; Set-Up Diagram - Mitsubishi Electric ME96NSR User Manual

4. Set-up

4.1 Set-up Diagram

For correct measurement, it is necessary to set the primary voltage and the primary current, etc. in the set-up mode.
It can set necessary items, after it shifts from the Operation mode to set-up mode. Items are not set is the initial setting.
In the case of normal use, it can use only by the set-up menu 1 (basic set-up). In the case to use the communication
function, set the set-up menu 2.
Refer to the next page or later for the set-up items.
Operation mode
Measurement display
End display
CANCEL display
Initializing
process
Shift
automatically
Example of
set-up mode
Example of set value
confirmation mode
blink
Set-up menu "End"
P-1
Type of option
display
(Example)
P-2
extinction
Set-up menu 1
Phase Phase
wire wire
Display Display
pattern pattern
Using VT/ Using VT/
direct input direct input
Direct Direct
voltage voltage
Secondary Secondary
voltage voltage
Primary Primary
voltage voltage
Primary Secondary
current current
Time constant
Primary
for current
current
demand
Time constant
Communication
for current
method
demand
ModBus
address
ModBus
baud rates
1. Make sure to set for Direct volt-
age, Secondary voltage, Pri-
ModBus
parity mary voltage, Secondary cur-
rent, Primary current.
ModBus
(Or check the set-up contents.)
stop bit
A correct measurement cannot
be done if the set-up contents
CC-Link
station
number are wrong.
2. Set for the other set-up contents
CC-Link
when it is necessary.
baud rates
When it is not done, it operates
Communication with the initial contents (refer
module reset
to page 66).
Set-up menu 2
Communication
method
ModBus
address
ModBus
baud rates
ModBus
parity
ModBus
stop bit
CC-Link
station
number
CC-Link
baud rates
Communication
module reset
Digital input
reset
CAUTION