Mitsubishi Electric ME96NSR User Manual page 9

2. Display and Key Functions
■Functions of operation key
Meaning of code : (press),
–
SET
✽1: Each the phase cyclic and the display cyclic are stopped.
✽2: It is available only that displayed element in the displayed Wh, varh.
✽3: The last digit is fast-forwarded for 4 step per second.
✽4: The one step up digit from the last one is fast-forwarded for 4 step per second. It is available only the set of the ModBus address and the set of
CC-Link station number.
Note: While the back light is off, if the operation key is pressed, the back light is always lit. If the operation button is pressed once again,
the function in the above table appears.
● If the function of "maximum value and minimum value reset" and "Wh, varh
zero reset" are done, data will be lost. Before the operation, please record data.
Notes
● If the function of "initializing of instrument" is done, the entire measurement
(measurement display, alarm, analog output, pulse) stops.
(press on over 1 second),
+
RESET MAX/MIN PHASE DISPLAY
SET
Set key
+/– key
(press on over 2 seconds),
Display changes.
Phase changes.
Mode changes to the max./min. display and the instantaneous display.
An alarm condition is canceled.
The item expressed with the bar graph is changed.
Stop the auto cyclical change.
(✽1)
Harmonics number changes at harmonics display.
The displays changes cyclically.
The phases changes cyclically.
All alarm conditions are canceled.
The latching data of digital input on the display is canceled.
The max./min. values on the display are reset to the instantaneous values.
All of the max./min. values are reset to the present values.
The counting values of 3 digits of low lank are displayed. After
pressing once again, the display returns.
All of the counting values are zero reset.
The display of set-up mode appears.
The display of set value confirmation mode appears.
The setup contents that is blinking is saved.
The setup contents is changed to next content.
The display of set-up menu appears. (At the final contents of the setup.)
The End display appears. (At the final contents of the setup in the
simplified set-up menu.)
After the setup contents are saved, the display on operation mode
appears if it is the End display.
After the setup contents are not saved, the display on operation mode
appears if it is the CANCEL display.
The display of set-up menu appears.
The End display appears. (In the simplified set-up menu.)
The values of set-up and number of the menu are changed.
(If it presses for 1 sec or more fast forward or fast return.)
The CANCEL display appears at the End display.
The values of set-up and number of the menu are changed. Then it is
carry up and fast forward or fast return.
Change the display of simplified set-up menu, and move to the start.
(The setup contents are saved.)
Back to the previous contents. (The setup contents are saved.)
The display of set-up menu appears. (At the start setup contents, and
at the display of the option module.)
The End display appears. (At the start setup contents in the simplified
set-up mode.)
The display of simplified set-up mode appears. (At blinking the "End"
in the set-up mode.)
The type of the option module appears. (At blinking the "End" in the
set-up mode.)
The instrument is initialized. (At the CANCEL display.)
RESET MAX/MIN PHASE DISPLAY
Reset Maximum/ Phase Display
key Minimum change change
key key key
(press simultaneously)
(✽2)
(✽3)
(✽4)