Front Panel Led Indicators; Parameter Setup - Radyne DMD50 Installation And Operation Manual

DMD50 Universal Satellite Modem

4.1.4 Front Panel LED Indicators

Eight LEDs on the Front Panel (Refer to Table 4-3) indicate the status of operation. The LED
colors maintain a consistent meaning. Green signifies that the indication is appropriate for normal
operation, Yellow means that there is a condition not proper for normal operation, and Red
indicates a fault condition that will result in lost communications.
LED
Power
Fault
Event
Remote
Transmit On
Major Alarm
Minor Alarm
Test Mode
Signal Lock
Major Alarm
Minor Alarm
Test Mode

4.2 Parameter Setup

The four Cursor Control Arrow Keys are used to navigate the menu tree and select the parameter
to be set. After arriving at a parameter that needs to be modified, depress <ENTER>. The first
space of the modifiable parameter highlights (blinks) and is ready for a new parameter to be
entered. After entering the new parameter using the keypad (Refer to Figure 4-2), depress
<ENTER> to lock in the new parameter. If a change needs to be made prior to pressing
<ENTER>, depress <CLEAR> and the display defaults back to the original parameter. Depress
<ENTER> again and re-enter the new parameters followed by <ENTER>.
TM118 – Rev. 1.1
Table 4-3.
Color
Modem LED Indicators
Green Indicates that the unit is turned on.
Red Indicates a hardware fault for the unit.
Yellow Indicates that a condition or event has occurred that the
modem has stored in memory. The events may be viewed
from the Front Panel or in the Terminal Mode.
Green Indicates that the unit is in the process of updating firmware
with FTP or flashing indicates some features are demo
enabled.
Modulator LED Indicators
Green Indicates that the transmitter is on.
Red Indicates that the Transmit Direction has failed, losing traffic.
Yellow Indicates that a Transmit Warning Condition exists.
Yellow Indicates that the transmitter is involved in a current Test
Mode activity.
Demodulator LED Indicators
Green Indicates that the receiver locked to an incoming carrier and
data, including FEC Sync.
Red Indicates that the Receive Direction has failed, losing traffic.
Yellow Indicates that a Receive Warning Condition exists.
Yellow Indicates that the receiver is involved in a current Test Mode
activity.
User Interfaces
Function
4-3