Table of Contents
Advertisement
DMD50 Universal Satellite Modem
Web Browser Setup Guide
F.0
Introduction
The Web Browser allows for connection to Radyne products through the Ethernet port. The Web
interface allows for complete control and monitoring of all equipment parameters and functions
via a 10Base-T Ethernet connection. Utilization of the Web browser is dependent upon proper
set-up of the TCP-IP menus. For TCP-IP setup guidelines refer to Appendix G in the manual.
For additional information on the various WEB configurations and descriptions refer to the
Remote Protocol Manual TM117.
Utilization of the Web Browser requires proper setup of the TCP-IP menus. The unit
is shipped from the factory with the Boot Mode configured as Default. Verify that
the Boot Mode is set for Default. To access the unit via the Ethernet port, set the
Boot Mode to IP TEST. This will set the IP parameter to an accessible address. If
user wants to utilize an alternate address, user must set the Boot Mode to NON-
VOL. Contact the IT manager for proper guidance to ensure setup is successful.
F.1
WEB Users Configuration
Radyne utilizes authentication and authorization together with a user database and a security
realm to design a secure site. This allows for the use of users and groups, where users are
generally people that may access the system, and groups represent the position that users can
hold.
The Modem's Front Panel has full administrative privileges, allowing the operator through the
Front Panel Menu entries to perform monitor and control modem parameter settings, change
other interface user names and passwords, and modify IP network settings.
TM118 – Rev. 1.1
Appendix F
F
F
-1
Advertisement
Table of Contents
