Rev 1.1
OK
!
Push Here
To insert a FAN Unit:
1. Make sure the mating connector of the new unit is free of any dirt and/or obstacles.
2. Insert the fan unit by sliding it into the opening until slight resistance is felt. Continue press-
ing the fan unit until it seats completely.
46
Mellanox Technologies
Figure 31: Fan Module Latches
OK
!
Latch release
The green fan status indicator should light. If not, extract the fan unit and reinsert it.
After two unsuccessful attempts to install the fan unit, power off the switch before
attempting any system debug.
OK
!
Extracting and Inserting FRUs
OK
!