Mellanox Technologies SwitchX-2 User Manual page 41

SwitchX®-2 60 Port Ethernet Switch System Hardware User Manual
sx-43 [standalone: master] > enable
sx-43 [standalone: master] # configure terminal
sx-43 [standalone: master] (config) # show interfaces mgmt0
The following is an example of the output:
Interface mgmt0 state
Admin up:
Link up:
IP address:
Netmask:
Speed:
Duplex:
Interface type:
Interface source:
MTU:
HW address:
Comment:
RX bytes:
RX packets:
RX discards:
RX errors:
RX overruns:
RX frame:
6. Run the command:
show version
7. Compare the results of this command with the latest version for your switch posted on the
support page for your
 Starting the Command Line (CLI)
1. Set up an Ethernet connection between the switch and a local network machine using a stan-
dard RJ-45 connector.
2. Start a remote secured shell (SSH) to the switch using the command "ssh -l <username>
<switch ip address>."
rem_mach1 > ssh -l <username> <ip address>
yes
yes
192.168.10.43
255.255.255.0
1000Mb/s (auto)
full (auto)
ethernet
physical
1500
00:02:C9:11:2A:AE
1343502058
17589211
RX mcast packets:
0
0
0
0
For managed switches, confirm that the latest SW revision is installed on this device.
Use the CLI to get the currently installed revision and then go to Mellanox.com to
check the revision of the latest version.
switch. This page will need a support login and password.
TX bytes: 313920869
TX packets: 992717
0
TX errors: 0
TX overruns: 0
TX carrier: 0
TX collisions: 0
TX queue len: 1000
TX discards:
Mellanox Technologies
Rev 1.1
0
41