Table of Contents
Advertisement
SwitchX®-2 60 Port Ethernet Switch System Hardware User Manual
The system status indicators should display as follows:
• when the switch is plugged in, within five minutes the STATUS LED should light up
green
• the FAN LED should light up green. If the FAN LED shows red, troubleshoot the fan
module. See "Troubleshooting" on page 52.
Table 3 shows the system status LED assignment.
Table 3 - System Status LED Assignments
LED Configuration
Solid Green
Flashing Green
Solid Yellow
Solid Red
Off
As long as there is power to the switch (one PS unit is connected), and the switch is
booted up and running, the status LED should be green.
If the STATUS LED shows red after five minutes, unplug the switch and call your
Mellanox representative for assistance.
If the switch shuts down due to over temperature, unplug the switch, wait 5 minutes
and replug in the switch. For more information See "Troubleshooting" on page 52.
PS
UID
RST
OK – The system is up and running.
The system is booting up. This assignment is valid on managed systems only.
To be implemented in a future SW release.
Major Error – Possible damage can result to the switch. Turn off immediately.
e.g. bad firmware, can't boot, overheated. If the system is booting up, it can take
up to 5 minutes for the status led to change to green.
Off – The system has no power.
STATUS/ System Health LED
Mellanox Technologies
Rev 1.1
15
Advertisement
Table of Contents
