SwitchX®-2 60 Port Ethernet Switch System Hardware User Manual
7
1
4
8
2
5
3
6
9
3.5.2
Port Speed Configuration
These SFP+ ports can be manually configured to run at speeds ranging from 1GbE to 10 GbE.
These QSFP+ ports can be manually configured to run at speeds ranging from 10GbE to 56 GbE.
To change the port speed configuration use the GUI, or use the CLI and go to the interface con-
figuration mode, then use the command "speed".
3.5.3
Management and Firmware Updating Interfaces
There are six interfaces to connect to the SX1024:
• 2 X 100M/1Gb Ethernet connectors labeled
• 1 USB port that is labeled
This interface can be used to update software or firmware.
• 1 connector that is labeled
Use this connector to connect to the host PC.
• 1 reset button
• 1 I2C banana connector on the power supply side for FAE use only
Figure 14: Port Numbering
13
16
19
22
25
28
10
14
17
20
23
26
29
11
12
15
18
21
24
27
30
Figure 15: Top and Bottom QSFP Port Orientation
Figure 16: Top and Bottom SFP+ Port Orientation
31
34
37
40
43
46
32
35
38
41
44
47
33
36
39
42
45
48
49
51
53
55
57
50
52
54
56
58
I2C
Mellanox Technologies
Rev 1.1
59
60
23