Rerunning The Wizard; Connecting To The Switch Platform; 4.11.1 Starting A Remote Connection To The Switch; Starting An Ssh Connection To The Switch (Cli) - Mellanox Technologies SwitchX-2 User Manual

Rev 1.1
3. Login to the switch (default username is admin, password admin)
4. Once you get the prompt, you are ready to use the system. Refer to MLNX-OS Command Ref-
erence Guide for additional information on the CLI commands.
4.10

Rerunning the Wizard

If you want to rerun the wizard run the following commands:
sx-43 [standalone: master] > enable
sx-43 [standalone: master]# configure terminal
sx-43 [standalone: master] (config) # configuration jump-start
4.11

Connecting to the Switch Platform

4.11.1 Starting a Remote Connection to the Switch

There are two ways to access the management CPU:
• Via the Ethernet connector for remote access:
• SSH
• Telnet
• Web
• SNMP
• XML
• Via KVM connections locally
4.12

Starting an SSH Connection to the Switch (CLI)

1. Set up an Ethernet connection between the switch and a local network machine ("the remote
machine" henceforth) using a standard RJ-45 connector.
2. Connect to the remote machine (rem_mach1 is used as an example).
3. Start a remote shell to the switch using the following command using 
<switch_IP_address> is the IP address of the switch.
rem_mach1 > ssh -l <username> <switch ip address>
Mellanox MLNX-OS® Switch Management
Password:
Last login: March 13, 2013 from 192.168.10.1
Mellanox Switch
sx-43 [standalone: master] >
4. You can enter any supported command now.
42 Mellanox Technologies
Mellanox MLNX-OS Switch Management
Last login: Thu Apr 28 11:24:13 2011 from 192.168.10.1
Mellanox Switch
switch >
Installation