Figure 22: Inserting The Caged Nuts; Figure 23: Slide The Rail Into The Rail Slide - Mellanox Technologies SwitchX-2 User Manual

60 port ethernet switch system

Hide thumbs Also See for SwitchX-2:

Table of Contents

SwitchX®-2 60 Port Ethernet Switch System Hardware User Manual

5. Clip 6 caged nuts into the holes in the rack on the side of the rack you will be sliding the

switch into. Check that both sides of the switch, power side and connector side, are at the

same level in the rack.

6. Clip 4 more caged nuts into the holes on the opposite side of the rack. Check that both sides of

the switch, left and right, are the same level in the rack.

7. Slide the rail into the rail slide.

8. Using two of the bolts for each corner install the rails and rail slides in the rack. Do not

tighten the bolts yet.

Figure 22: Inserting the Caged Nuts

This side of the rail kit goes on the side of the rack you will

slide the switch into. This is the same side of the switch that

will be next to the vertical support.

Side you will slide

the switch into

Second side

Mellanox Technologies

Rev 1.1

Table of Contents