Mellanox Technologies SwitchX-2 User Manual page 38

Rev 1.1
Table 11 - Configuration Wizard Session - IP Configuration by DHCP (Sheet 2 of 2)
Wizard Session Display (Example)
Step 5: Admin password (Press <Enter> to leave
unchanged)? <new_password>
Step 6: Confirm admin password?
<new_password>
You have entered the following information:
1. Hostname: <switch name>
2. Use DHCP on mgmt0 interface: yes
3. Enable IPv6: yes
4. Enable IPv6 autoconfig (SLAAC) on mgmt0
interface: no
5. Admin password (Enter to leave unchanged):
(CHANGED)
To change an answer, enter the step number to
return to.
Otherwise hit <enter> to save changes and exit.
Choice: <Enter>
Configuration changes saved.
To return to the wizard from the CLI, enter the
"configuration jump-start" command from con-
figuration mode. Launching CLI...
<switch name>
38 Mellanox Technologies
To avoid illegal access to the machine, please type a password
and then press <Enter>. Then confirm the password by re-enter-
ing it.
Note that password characters are not printed.
The wizard displays a summary of your choices and then asks
you to confirm the choices or to re-edit them.
Either press <Enter> to save changes and exit, or enter the config-
uration step number that you wish to return to.
Note:
To run the command "configuration jump-start" you must be in
Config mode.
Comments
Installation