Table 5: Bad Port Led Configurations - Mellanox Technologies SwitchX MSX1016X-2BFR Hardware User Manual

SwitchX® 64 Port SFP+ Ethernet Switch Hardware User Manual
Fans must be operating while the power supply is plugged in.
If the switch shuts down due to over-temperature, unplug the switch, wait 5 minutes
and replug in the switch. For more information See "Troubleshooting" on page 31.
3.1.1.4 Bad Port LED
The bad port indicator is located on the left side of the front panel (connector side) of the unit.
The following bad port conditions are possible:
Table 5 - Bad Port LED Configurations
LED Configuration
Off
Flashing Orange
This LED shows symbol errors. Possible causes for this are:
• bad cable
• bad connection
• bad connector
This LED lights up when one or more ports is receiving a symbol error. The LED immediately
goes off until the next symbol error is received.
3.1.1.5 UID LED Switch Identifier
The UID LED is a debug feature that will become available to customers in the near future. For
details please contact Mellanox Technologies support.
3.1.1.6 Port Connector LED
The port LEDs are assigned to the ports as in figure:
OK – all ports are up and running.
Error – one or possibly more ports has just received a symbol error.
Description
Mellanox Technologies
Rev 1.2
17