Repeater Function (Wds) - Siemens Gigaset SE365 WLAN Operating Instructions Manual

Configuring the Advanced Settings

Repeater function (WDS)

Only Repeater operating mode
If you use the device in Repeater operating mode and want to increase the range in your
wireless network, you must configure the Wireless Distribution System (WDS) function.
You can enter or choose an access point for which you wish to extend the range of the
wireless network. The WDS function must be activated on the access point. To do this,
please refer to your access point's user guide.
ì
In the Wireless Network menu, select Repeater (WDS).
All WLAN devices in range with activated WDS function are shown.
ì
Click Refresh to update the display.
ì
Enter the MAC address of the access point or select an access point from the list of
available access points by clicking Add.
ì
Enter a name for the access point in the Comment field. This name will allow you to
identify the various devices more easily. The SSID is the default setting.
If there is a connection
– the MAC address of the access point is shown in the MAC address field.
– the SSID of the access point is shown in the SSID field.
– the radio channel used for data transfer is shown in the Channel field.
– the Signal strength shows the strength of the connection in percentage terms.
ì
Click Delete to delete an entry.
ì
Apply the settings by clicking OK.
60