Siemens Gigaset SE365 WLAN Operating Instructions Manual page 85

Appendix
Problem
You cannot access
the Gigaset SE365
WLAN from a PC,
for example to call
the configuration
program (connec-
tion via LAN cable).
82
Possible cause
The connection
between the PC and
the Gigaset SE365
WLAN is interrupted.
The LED for the LAN
socket does not light
up.
The PC's network
settings are wrong.
Your PC is configured
to automatically
obtain IP addresses,
but the DHCP server
of your Gigaset WLAN
repeater has been
switched off.
The IP address of your
Gigaset SE365 WLAN
has changed as you
have activated the
Obtained automati-
cally option (see
page 46).
Remedy
ì
Check the cable connection
(see above).
ì
Make sure that the PC has the right
configuration for connecting to the
Gigaset SE365 WLAN, for example
that the IP address and subnet mask
have been set correctly or the
obtaining the IP address automati-
cally option has been activated.
ì
Manually assign a static IP address
for your PC in the Gigaset SE365
WLAN address block.
ì
Check the log of your DHCP server,
from which the Gigaset SE365
WLAN obtained its IP address, to see
which IP address was assigned to it
and enter this address in your
browser. Try resetting your Gigaset
SE365 WLAN to the factory settings
to once again obtain access via
address 192.168.2.254 (see
page 14).