Siemens Gigaset SE365 WLAN Operating Instructions Manual page 15

First Steps
LED displays
The front panel of the Gigaset SE365 WLAN contains LED displays that show the oper-
ating state and simplify installation and fault finding in the network.
The LEDs show the following:
LED State
Repeater On/Off
AP On/Off
Adapter On/Off
On
LAN Flashing
Off
In normal operation:
On
Flashing
WLAN
Off
During WPS registration:
On (300 s)
Flashing slowly
Flashing quickly
Flashing quickly
with interruption
On
Power
Off
12
Status
Shows the device's current operating mode
(Repeater, Access point, Ethernet adapter). You can
change the operating mode via the Mode button on
the back panel.
There is a connection to the local network via the
Ethernet cable.
The Gigaset SE365 WLAN is sending or receiving
data via the Ethernet cable.
There is no connection to the local network via the
Ethernet cable.
There is a wireless connection to the local network.
u
The Gigaset SE365 WLAN is sending or receiving
data on its WLAN interface.
u
New firmware is being loaded on the Gigaset
SE365 WLAN or the Gigaset SE365 WLAN is
rebooting.
The WLAN interface is not active.
WPS registration was successful.
WPS registration is in progress.
WPS registration was not successful.
More than one client tried to register.
The Gigaset SE365 WLAN has been powered up.
The Gigaset SE365 WLAN has been powered down.