Switching Between Full Screen Video And The Home Screen; Showing, Moving, And Turning Off The Pip - Polycom VSX Series Getting Started Manual

G S G
ETTING TARTED UIDE FOR THE

Switching Between Full Screen Video and the Home Screen

Showing, Moving, and Turning Off the PIP

12
VSX S
ERIES
To delete all presets:
1. If a call is connected, press
source.
2. Press Preset on the remote control.
3. Press Delete to delete all presets.
You cannot delete just one preset. Instead, override an existing preset with the new
camera position.
Before the call connects, you see the near video in a small window on the
Place a Call (home) screen. When the call connects, the system automatically
shows the video in the whole screen. You can switch back to the Place a Call
screen during a call, for example, if you need to adjust a user setting, and
your system is configured to allow you to do so.
To learn about adjusting user settings, see Customizing Your Workspace on page 34.
To see the video in the full screen:
>>
Press Near on the remote control.
To see the Place a Call screen:
>>
Press Home on the remote control.
During a call on a single-monitor system, the Picture-in-Picture (PIP) displays
what your main camera is sending to the far site. (This lets you adjust the
camera if you need to.) If the far site shows any type of content, the content
appears in the main part of the screen, and the PIP changes to show the
people at the far site.
During a call on a dual-monitor system, what you see on each monitor and in
the PIP depends on how the VSX system has been configured.
Near to choose a near-site video
.
WWW POLYCOM
. /
COM VIDEODOCUMENTATION