Switching Between Full-Screen Video And The Home Screen; Enabling Dual Monitor Emulation - Polycom V500 Getting Started Manual

Getting Started Guide for the V Series

Switching Between Full-Screen Video and the Home Screen

Enabling Dual Monitor Emulation

10
To store a preset:
1. When you are in a call, press
other video source.
2. If you selected a far-site camera that supports electronic pan, tilt, and
zoom, you can adjust the camera's position:
— Press the arrow buttons on the remote control to move the camera up,
down, to the left, or to the right.
— Press Zoom to zoom the camera out or in.
3. Press Preset on the remote control.
4. Press and hold a number to store the preset position. To store a
double-digit preset, press the first digit quickly and hold the second
number down. Any existing preset stored at the number you enter is
replaced.
When the call connects, the system automatically shows the video on the
whole screen. You can switch back to the home screen during a call if, for
example, you need to adjust a user setting, and your system is configured to
allow you to do so.
To see the video in the full screen:
 Press Near on the remote control.
To see the home screen:
 Press Home on the remote control.
Depending on your system configuration, you may be able to set your system
for Dual Monitor Emulation (also called split-screen viewing). With Dual
Monitor Emulation, you can see both the near and far sites on one monitor.
To enable Dual Monitor Emulation:
1. Select System from the Place a Call screen.
2. Select User Settings from the System screen.
3. Select Next to see more settings.
Far, then choose a far-site camera or
© Polycom, Inc.