Konica Minolta BIZHUB PRO 1050E Operator's Manual page 532

13
Procedure
1
Touch [Adjustment] - [02 Finisher Adjustment] - [05 Saddle Stitcher
Adj.].
2
Touch [07 Trimming Adjustment] to display the Trimming Adjustment
Screen.
3
Touch the [COPY] tab to display the Copy Screen.
4
Load the desired size of paper to be adjusted on a tray, specify
Fold&Staple, then press [Start].
A sample pattern (No. 16) will be output.
5
Check the trimmed width (a) from the edge of the feeding sheet.
6
If the desired result cannot be obtained, touch the [ADJUSTMENT] tab.
7
Touch [Next] or [Back] to select the paper size to be adjusted.
Touching [Next] continuously will change the paper size as follows.
All Size - 11x17 - A3 - B4 - 8.5x14 - A4R - 8.5x11R - B5R - 8x13 -
8.12x13.2 - 8.5x13 - 8.25x13 - 8K - 16KR - 12x18 - A3W - B4W - A4WR
- B5WR - 12x18W - 11x17W - 8.5x11WR - Special
8
Use the touch panel keypad to enter the desired adjustment value, then
touch [Set].
Available range: -400 (wide) to +400 (narrow), 1 step = 0.1 mm
9
Repeat the adjustment steps from 3 to 8 until the desired result is ob-
tained.
10
Touch [Return] to restore the Saddle Stitcher Adjustment Mode Menu
Screen.
13-74
a
2.0 mm or more
Adjustment
bizhub PRO 1050/1050e