Selecting Paper Size; To Select Paper Size Automatically (Aps); 1S2, 2S2 - Konica Minolta 7045 Instruction Manual

Selecting Paper Size

To select an appropriate paper size for getting your desired copy result, use APS
(Automatic Paper Selection), or select paper size manually on the touch screen, as
required.
I To Select Paper Size Automatically (APS)
APS detects the size of originals placed on the RADF
or platen glass and automatically selects and feeds copy
paper of the same size, or selects an appropriate size
according to the magnification ratio selected.
1
Touch to highlight
right corner of the Basic Screen.
APS
is already highlighted when the initial set-
tings are restored.
2
Select additional copy conditions, as
desired.
3
Enter the desired print quantity from the
control panel keypad.
4
Position original(s).
APS
at lower
HINTS
See the table on the following
page for the relation of origi-
nal size, magnification ratio
and copy paper size.
HINTS
The initial settings may have
been altered by Key operator.
See p. 12-6 to p. 12-11.
HINTS
See p. 3-6 for details on set-
ting print quantity.
HINTS
• See p. 9-5 to p. 9-6 for pa-
per sizes detectable from
the RADF or on the platen
glass.
• See p. 3-2 to p. 3-5 for de-
tails on positioning originals.
• Key operator can deactivate
APS when original is set in
the RADF or on the platen
glass. See p. 12-34 to p. 12-
37.
3
Copying
Operations
Positioning
Originals
Setting
Print Quantity
Paper Size
Lens Mode
Density

1s2, 2s2

2s1
Using
Memory
Output without
Finisher
FS-109
Output Modes
Check Mode
& Proof Copy
Interrupt
Mode
3-7