Table of Contents
Advertisement
[10] Touch Panel Adjustment
Use this feature to check the malfunction of the LCD touch screen due to the shift in
position of the touch sensor.
❒ When the Touch Panel Adjustment Screen does not display in step 2, press one from keypad [0] ~
[9].
Procedure
1 Touch 10. Touch panel adj on the Key Operator Mode Screen to display the Touch
Panel Adjustment Screen.
2 Touch the "+" indication at the upper right and lower left corners on the Control Panel
Adjustment Screen. The present coordinates will be displayed in the message area
of the screen.
NOTE:
When touching the "+" indications, it is recommended that you use a sharp point such as a pencil
to be much more accurate.
3 Check that the X coordinate and Y coordinate displayed in the first line of the mes-
sage area fall within the standard value displayed in the second line.
4 Touch the CHECK s at the upper left and lower right corners on the screen to check
if the buzzer tone functions normally.
5 If the coordinates fall out of the range of the standard value in step 3 , or the buzzer
tone does not sound in step 4 , repeat the adjustment procedure from 2 to 4 , or
contact Konica service centre.
6 Press [START] on the control panel to complete the setting.
12-32
Advertisement
Chapters
Table of Contents
