Safety Instruction - ACME DVS-2500 User Manual

DVS-2500

1. Safety Instruction

Please read carefully the instruction manual which includes
important information about the installation usage and maintenance.
WARNING
Please keep this User Manual for future consultation. If you sell the unit to another user, be
sure that they also receive this instruction manual.
Important:
Damages caused by the disregard of this user manual are not subject to warranty.
The dealer will not accept liability for any resulting defects or problems.
Unpack and check carefully that there is no transportation damage before using the
unit.
The unit is for indoor use only. Use only in a dry location.
Do install and operate by qualified operator.
Do not allow children to operate the fixture.
Use safety chain when fixing the unit. Handle the unit only by carrying its base instead
of head .
The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces.
Be sure that no ventilation slots are blocked, otherwise the unit will be overheated.
Before operating, ensure that the voltage and frequency of power supply matches the
power requirements of the unit.
It's important to ground the yellow/green conductor to earth in order to avoid electric
shock.
Don't connect the device to any dimmer pack.
During initial start-up, some smoke or smell may arise. This is a normal process and
does not necessarily mean that the device is defective, and it will decrease gradually
within 15 minutes.
Make sure there are no flammable materials close to the unit while operating to avoid
fire hazard.
Examine the power wires carefully; replace them immediately if there is any damage.
Unit's surface temperature may reach up to 85℃. Don't touch the housing bare-handed
during its operation, and allow about 15 minutes for cooling the unit down before
replacing bulb or maintenance as it could be very hot.
3-