Advertisement
1. Safety Instruction
Please read the instruction carefully which including important
information about the installation, operation and maintenance.
WARNING
♦ Please keep this User Manual for future consultation. If you sell the unit to another user,
be sure that they also receive this instruction booklet.
♦ Unpack and check carefully there is no transportation damage before using the unit.
♦ Before operating, ensure that the voltage and frequency of power supply match the power
requirements of the unit.
♦ It's important to ground the yellow/green conductor to earth in order to avoid electric
shock.
♦ The unit is for indoor use only and use only in a dry location.
♦ The unit must be installed in a location with adequate ventilation, at least 50cm from
adjacent surfaces. Be sure that no ventilation slots are blocked.
♦ Disconnect mains power before fuse replacement or servicing.
♦ Replace fuse only with the same type.
♦ Make sure there are not flammable materials close to the unit while operating as it is fire
hazard.
♦ Use safety cable when fixes this unit.
♦ In the event of serious operating problem, stop using the unit immediately. Never try to
repair the unit by yourself. Repair carried out by unskilled people can lead to damage or
malfunction. Please contact the nearest authorized technical assistance center and
always use the same type spare parts.
♦ Do not touch any wire during operation as high voltage might be causing electric shock.
2A
2. Technical Specification
• It can be operated by DMX512 control or can be used as an individual unit without
controller.
• It can be linked together as many as required in master/slave mode, and perform the great
built-in programmed lighting shows triggered by music.
• Please use a 3 pin XLR cable/plug when connecting them together.
• Fan cooled.
• 3 Channels
Channel 1 = Dimmer/Strobe
Channel 2 = Color
Channel 3 = Rotation
• Voltage: AC 100V-240V 50/60Hz
• Fuse: T 1A
• Power: 13 W
• LED： 1X3W RGB LED
• Dimension: 210X210X179 mm
• Weight: 1.8kg
3. Installation
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is
firmly fixed to avoid vibration and slipping while operating. Always ensure that the structure
to which you are attaching the unit is secure and is able to support a weight of 10 times of
the unit's weight. Also always use a safety cable that can hold 12 times of the weight of the
unit when installing the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place where is out
of the touch of people and has no one pass by or under it.
3A
Advertisement
