ACME DVS-2500 User Manual page 21

Image Auto Inverse
Select Image Auto Inverse, press ENTER button to confirm, present mode will blink
on the display, press UP/DOWN button to select No (normal) or Yes (Image auto
inverse while the DMX value of tilt is over 128 ), press ENTER button to store. Press
MENU button back to the last menu or let the unit idle one minute to exit menu mode.
Lamp Setting
Attention: The lamp will not be on until detected temperature is lower than 45
Enter menu mode, select Lamp Setting, press ENTER button to confirm, press
UP/DOWN button to select On/Off, State/Power on, Off Via Dmx, On if Dmx on, Off
if Dmx off, or Ignition Delay..
On/Off—Turn on/off the lamp
Select On/Off, press ENTER button to confirm, present mode will blink on the display,
press UP/DOWN button to select On (lamp on) or Off (lamp off), press ENTER button
to store. Press MENU button back to the last menu or let the unit idle one minute to exit
menu mode.
State/Power On—Lamp state while power on
Select State/Power On, press ENTER button to confirm, present mode will blink on the
display, press UP/DOWN button to select On (Lamp on while power on) or Off (Lamp
off while power on), press ENTER button to store. Press MENU button back to the last
menu or let the unit idle one minute to exit menu mode.
Off Via Dmx—Turn off the unit via Dmx controller
Select Off Via Dmx, press ENTER button to confirm, present mode will blink on the
display, press UP/DOWN button to select Yes (Enable the function of turning off the unit
via Dmx controller) or No (Disable the function of turning off the unit via Dmx controller),
press ENTER button to store. Press MENU button back to the last menu or let the unit
idle one minute to exit menu mode.
(When you operate the unit via DMX controller, set the value of channel "special
function" to "lamp off", waiting for 8 seconds, then the lamp will be off if you choose
"yes" mode).
DVS-2500
C.
°
20-