Selecting The Paper Source; To Make Copies Using The Auto Paper Function - Konica Minolta Di1611 Advanced Information

Before Making Copies
5.5

Selecting the Paper Source

The paper used for making copies can be selected in two ways.
Auto Paper:
If the Auto Paper function is selected, the paper tray containing the
most suitable size of paper is selected based on the size of the
document and the specified zoom ratio.
Manual paper selection:
The paper that you wish to use for copying can be selected.

To make copies using the Auto Paper function

1
Load the document into the Automatic Document Feeder.
Refer to "Loading the Document" on page 3-8.
2
Press the [Auto Paper/Auto Size]
key until the Auto Paper function is
selected.
Check that "AUTO" appears in
the bottom line of the screen.
3
If necessary, specify any other copy
settings.
Zoom (p. 5-28)
Copy density (p. 5-34)
Advanced Copy Operations (p. 6-1)
4
Using the 10-Key Pad, enter the desired number of copies, and then
press the [Start] key.
Note
If "NO SUITABLE PAPER" appears in the display immediately after
the [Start] key is pressed, no tray is loaded with paper of the most
suitable size. Either load paper with the appropriate size, or press the
[Paper] key and select the desired paper size, and then press the
[Start] key again.
Di1611/Di2011
5
5-21