Selecting A Special Ratio For Non-Standard Paper - Konica Minolta 2230 User Manual

Basic Operations
The Basic Screen (continued)
Lens Mode (continued)

Selecting a Special Ratio for Non-Standard Paper

To determine reduction or enlargement ratios when using non-standard paper sizes, refer to the
Special Ratio Table on the previous page, and follow the procedure below.
1 First, determine the correct ratio, as follows:
Original-Copy Width
Locate the original width on the horizontal axis.
Then, locate the copy width on the vertical axis.
Find the ratio on the table where these two values meet.
Original-Copy Length
Locate the original length on the horizontal axis.
Then, locate the copy length on the vertical axis.
Find the ratio on the table where these two values meet.
Determining an Appropriate Ratio
Use the smaller ratio for reduction, or use the larger ratio for enlargement.
2 Press [F3 (1:1)] to enter the Magnification selection screen.
3 Press [F1 (ZOOM)] to display the Zoom screen.
4 Use the keypad to enter the desired reduction or enlargement ratio, in 3 digits; or, press
[F3 ( )] and [F4 ( )] to scroll to the desired ratio.
5 When the desired ratio is displayed, press [OK] to complete the setting and return to the
Basic screen.
To cancel the setting, press [AUTO RESET].
6 When all other settings are acceptable, press [START PRINT].
5-10 Basic Operations