Copying Onto Manually Fed Paper By Multiple Bypass - Konica Minolta Di1611 Advanced Information

5

Copying Onto Manually Fed Paper by Multiple Bypass

1
Load the document to be copied.
Refer to "Loading the Document" on page 3-8.
2
Adjust the Bypass Tray Extender
and the paper guides to fit the size
of the paper.
3
Load the paper with the front side
facing down, lightly sliding the paper
as much as possible into the feed
slot.
The manual bypass mark (
appears in the bottom line of the
screen.
?
Are sheets of cards or postcards loaded?
Make sure that they are not curled (rolled).
4
Check that "YES/NO" appears in
the bottom line of the screen, and
then press the [No] key.
The "PAPER SOURCE SETUP"
menu appears.
Note
"YES/NO" is displayed for approximately 5 seconds after paper is
loaded into the Multiple Bypass.
5
Use the
the type of paper loaded.
Select from the following four
paper type settings.
"PLAIN"
"OHP"
"CARD"
"ENVELOPE"
6
Press the [Yes] key.
The PAPER SIZE menu appears.
5-18
)
and keys to select
Before Making Copies
Di1611/Di2011