MAINTENANCE WORK ON CHASSIS AND ENGINE
Glass fiber yarn filling of main silencer
9.73
The main silencer is filled with glass fiber yarn.
Over a period, the fibers of the insulating material vanish into the air, and the silencer "burns out".
Not only is the noise level higher, the performance characteristic changes.
Removing the glass fiber yarn filling of the main silencer
9.74
Warning
Danger of burns The exhaust system gets very hot when the vehicle is driven.
–
Allow the exhaust system to cool down. Do not touch hot components.
Installing the glass fiber yarn filling of the main silencer
9.75
Removing the air filter
x
9.76
Note
Engine failure Unfiltered intake air has a negative effect on the service life of the engine.
–
Never ride the vehicle without an air filter since dust and dirt can get into the engine and result in increased wear.
Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Position the collar sleeves.
–
Mount and tighten screw
Guideline
Remaining screws, chassis
700512-10
–
Remove the main silencer. (
–
Remove screws
–
Pull the glass fiber yarn filling
–
Clean the parts that are to be reinstalled.
700514-01
–
Slide the glass fiber yarn filling
–
Slide the outer tube
–
Insert the locking cap
lock washer.
Guideline
Remaining screws, chassis
–
Install the main silencer. (
700514-10
–
Remove the seat. (
.
M6
x
p. 51)
of locking cap
. Remove locking cap and outer tube
from the inner tube.
x
over the inner tube.
over the glass fiber yarn filling.
into the outer tube. Fit and tighten screws
M6
p. 51)
p. 48)
52
10 Nm (7.4 lbf ft)
.
with tooth
10 Nm (7.4 lbf ft)