Greasing The Steering Head Bearing; Dismounting The Front Fender; Installing The Front Fender; Removing Headlight Mask With Headlight (Exc-F, Exc-F Six Days, Xcf-W Za) - KTM 250 EXC-F EU Owenrs Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Greasing the steering head bearing

13.36

Dismounting the front fender

13.37

Installing the front fender

13.38
Removing headlight mask with headlight (EXC‑F, EXC‑F SIX DAYS, XCF-W ZA)
13.39
x
(EXC‑F SIX DAYS, XCF‑W USA, XC‑F, SX‑F)
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
(EXC‑F EU, EXC‑F AUS, XCF‑W ZA)
–
Remove the lower triple clamp.
–
Install the lower triple clamp.
800010-10
–
Remove screws
–
Make sure that the distance bushings remain in place.
600692-10
–
Ensure that the spacing sleeves are mounted in the fender.
–
Position the front fender. Mount and tighten screws
Guideline
Remaining screws, chassis
Info
Take care with the contact between the holding lugs and the start number
plate or headlight mask.
600692-10
–
Switch off all electrical equipment.
–
Remove screw
–
Loosen the rubber band
600703-10
–
Pull out the electric plug connector
headlight.
600702-10
x ( p. 50)
x ( p. 51)
( p. 51)
x
( p. 52)
x
. Remove the front fender.

M6
and take off clamp.

. Push up the headlight mask and swing it forwards.

and remove the headlight mask with the

.

10 Nm (7.4 lbf ft)
53