Image In Mcf - Konica Minolta 9750 Manual

page 60 for details. Available settings are
ON(default) and OFF.
03 ERR REPORT(MCF): This function
automatically prints a Message Confirmation
Report each time an error occurs during a
transmission or polling transmission operation.
The report provides information about the
transmission—see page 64 for details. Available
settings are ON (default) and OFF.
When a message

04 IMAGE IN MCF:

confirmation of a memory transmission is printed,
this function adds a portion of the first page of the
document that was sent. This feature makes it
easier to identify a fax, but it may present security
problems if you are sending sensitive documents.
Available settings are ON (default) and OFF.
05 SENDER ID: This function controls the
printing of your Konica Fax's Sender ID on the
faxes you send. See page 23 for details. When
turned on, the Sender ID will be printed on each
page slightly outside the image area of your
document. The default setting is ON.
Note: In order to meet FCC requirements, you must
have this feature set to ON and have a valid Sender ID
programmed in your machine.
06 MONITOR VOLUME: This function sets the
volume for telephone line monitoring during dialing.
Available settings are LOW (default), HIGH, and
OFF.
07 BUZZER VOLUME: This function sets the
volume of the various tones your machine emits
during operation. Available settings are LOW,
MIDDLE (default), and HIGH.
08 CLOSED NETWORK: This function allows
you to program your machine to refuse to commu-
nicate with locations whose telephone numbers
have not been programmed into your One Touch
keys or Auto Dial locations. Using this function,
you can set up a closed network of fax ma-
chines—see page 40 for details. If you do not
want your machine to transmit faxes to or receive
faxes from locations outside your network, select
T/R. If you only want your machine to refuse to re-
ceive faxes from outside your network, select RX.
Available settings are OFF (default), T/R, and RX.
09 TX MODE DEFAULT: Your machine is set for
the STD (standard) resolution setting and the
NORMAL contrast setting. If you consistently
send faxes that require some other combination of
transmission modes, use this function setting to
change the default modes. While you are