Konica Minolta 9750 Manual page 31

To Do This Use
Enter numbers Numeric keypad (press once)
Enter spaces 14/Space One Touch key
Enter hyphens (-) Hyphen key
Enter pauses (i.e., to wait for 15/Pause One Touch key
long distance or outside lines)
Add a switch from pulse */Tone key
to tone dialing for part
of the call
Move the cursor to Yes
make corrections
6 Press the Start key to enter the number.
7 Enter the Location ID. This is a descriptive title up
to 16 characters long. Refer to the instructions
below.
To Do This Use
Enter numbers Numeric keypad (press once)
Enter spaces Space One Touch key
Enter hyphens (-) Hyphen key
Enter alphabet characters Locate the character you want on the numeric key
pad. Press that key repeatedly until the character
appears in the display.
Enter a unique character Press the 0/Unique key repeatedly until the character
you want appears in the display. The following char
acters are available: ! # & ' ( ) * + , - . / : ; = ? · ä ß ñ ö
ü Æ Å Ø æ å ø.
Enter two successive Press the No
numbers on character.
the same key.
Move the cursor to Yes
make corrections
and No keys
key to move to the next letters/
and No keys
8 Press the Start key. The display shows
NO=<OR LOCATION> for about three seconds.
9 Enter the optional alternate fax number, if desired.
Refer to the instructions following Step 5.
10 Press the Start key to finish programming the
One Touch key. The display shows LOCATION
PROGRAMMING.
11 To continue programming One Touch keys, go
back to Step 3. If you are finished programming,
press the Select Function key.
12 Lift off the plastic cover above the One Touch
label. Using a pencil, write in the location name for
your One Touch key(s). Then replace the cover.
If you are experiencing problems communicating
with a remote location in a very noisy telephone
area, set up a One Touch key for that location and
try turning Echo Protection on for that One Touch
key. This helps the machine overcome noise and
echo problems on the phone line.
See the Problem Checklist sections for other
suggestions.
1 Press the Select Function key.
2 Press the 9/User Program One Touch key.
The display shows 1:FUNC. PROGRAMMING.