VCS VideoJet 8000 User Manual page 97

Chapter 5 Configuration using a Web Browser
Video loss alarm 1-4 ... Video loss alarm 5-8:
Select On if the VideoJet 8000 is to give an alarm when the video signal is
interrupted.
1./2. SNMP host address:
Enter the IP addresses of up to two chosen receivers here if the alarm message
is to be sent via SNMP-traps.
Alarm connections
You can select a number of options for the response of the VideoJet 8000 to an
alarm. In case of an alarm, the VideoJet 8000 can establish a connection to a
predefined IP address (VCS hardware receiver or PC with receiver software)
automatically. You can enter up to 10 IP addresses which will be selected in
sequence by the unit until a connection is established. You can also choose
which camera image should be automatically be displayed first on the receiver in
the case of an alarm.
Connect on alarm:
Select On so that the VideoJet 8000 establishes a connection automatically to
one of the pre-defined IP addresses in the event of an alarm.
Number of video receiver address:
Here you assign the numbering for the IP addresses to be contacted in the event
of an alarm. The unit contacts the remote locations one after the other in the
numbered sequence until a connection has been established.
VideoJet 8000 97