Chapter 7 Maintenance And Upgrades; Testing The Network Connection; Repairs - VCS VideoJet 8000 User Manual

Maintenance and Upgrades

Testing the network connection

The ping command can be used to check the connection between two IP
addresses. This allows you to test whether a unit is active on the network.
– Open the DOS command prompt.
– Type ping followed by the IP address of the unit.
If the unit is found, the response appears as Reply from ... followed by the
number of bytes sent and the transmission time in milliseconds. Otherwise, the
unit cannot be accessed via the network. This might be because
The unit is not properly connected to the network. Check the cable
connections in this case.
The unit is not properly integrated into the network. Please check the
IP address, subnet address and gateway address.

Repairs

Warning!
Never open the casing of the VideoJet 8000 yourself, there are no user
serviceable parts inside.
Ensure that maintenance or repair work is performed only by qualified personnel
(electrical technicians), or contact your VCS service center.
VideoJet 8000
7
131