Control Cabinet Installation - VCS VideoJet 8000 User Manual

Installation

Control cabinet installation

The VideoJet 8000 is ready for installation in a 19" rack. The necessary mounting
kit is included with the delivery.
Warning!
When installing in cabinets, ensure that each unit has adequate ventilation.
The free space around the unit must be at least 5 cm on the right and left
sides and at least 10 cm in the back.
The ambient temperature must be between 0 and +50 °C. The relative
humidity should not exceed 80%.
The unit generates heat during operation. Ensure that there is enough
clearance between the unit and heat-sensitive objects or equipment.
When installing additional units, direct contact with the VideoJet 8000 is
permitted if the surface temperature of the adjacent units does not exceed
+50 °C.
Unit installation
– Remove both screws on the front part of the right and left sides of the unit.
– Place both brackets from the mounting kit in the recesses by the screw holes
on the housing and attach them firmly using the four screws.
– Set the unit in the cabinet and attach the brackets to the frame using the four
screws, washers and lock nuts included in the kit.
– Insert the connector of the power cable in the power receptacle on the rear
side of the unit.
18
Chapter 4
VideoJet 8000