VCS VideoJet 8000 User Manual page 103

Chapter 5
Unit IP address:
Enter the desired IP address for the VideoJet 8000 in this field. The IP address
must be valid for the network.
Subnet mask:
Enter the subnet mask here if the unit is to communicate via a subnet.
Gateway IP address:
Enter the corresponding IP address here if the unit is to establish a connection
independently outside the local network. Otherwise, this field can remain empty
(0.0.0.0).
Ethernet link type:
If the VideoJet 8000 is connected to the network via a switch, both devices must
be set for the same type of network connection. If necessary, ask your network
administrator about the switch setting.
The value can be set to 10 MBit/s, 100 MBit/s or 1 GBit/s and full or half-duplex
mode (FD or HD) or to Auto if the network connection is to be flexible for
individual cases.
Warning!
Errors such as picture interference can occur if the setting of the
VideoJet 8000 differs from the connected switch, such as when the
switch is set to Auto and the VideoJet 8000 to 10 MBit/s HD.
DNS server IP address:
When operating a unit over the Internet, an address pool with dynamic addresses
is used for greater efficiency. This means that the unit is assigned an IP address
each time a connection is made and this address varies. In this case, access is
easier if the unit is listed on a DNS server. It will contact the server at regular
intervals and register its unit name and IP address. To connect to the
VideoJet 8000 via the Internet, it is enough to enter the unit name and the URL
of the DNS server. The server returns the current Internet IP address for the
connection.
The DNS server for VCS videotec.info is preset as the default. The associated
IP address is 195.145.107.78. The VideoJet 8000 contacts this server
automatically if the desired refresh interval is entered for the next parameter. If
VideoJet 8000
Configuration using a Web Browser
103